Are you preparing for C1000-063 IBM Tivoli Network Manager V4.2 Implementation Exam? Passcert new released IBM C1000-063 Exam Dumps to help you increase your confidence of passing IBM C1000-063 exam. Our Passcert C1000-063 Exam Dumps have 95% similarity with the real exam, it can make you feel easy to write your C1000-063 exam. With Passcert C1000-063 Exam Dumps, your IBM Certified Deployment Professional certification C1000-063 exam can be easy passed.

An IBM Certified Deployment Professional - IBM Tivoli Network Manager V4.2 is a technical professional responsible for the planning, deployment, administration, and troubleshooting of IBM Tivoli Network Manager V4.2. This individual will be expected to perform these tasks with limited assistance from peers, product documentation, and support resources. There are 45 questions in the real test, you need to answer 43 questions correctly to pass this exam, time duration is 90 minutes.Passing IBM C1000-063 exam will help you get IBM Certified Deployment Professional - IBM Tivoli Network Manager V4.2 certification.

Describe the IBM Tivoli Network Manager V4.2 architecture 

Design an IBM Tivoli Network Manager V4.2 architecture

Install and configure IBM Tivoli Network Manager V4.2 

Administer IBM Tivoli Network Manager V4.2  

Troubleshoot IBM Tivoli Network Manager V4.2

Knowledge of OMNIbus and DASH/JazzSM, TCR

Knowledge of networks and network management 

Knowledge of SQL 

Use of scripting languages

Basic Systems Administration skills

Planning    20%

Installation      26%

Administration     34%

Troubleshooting    20%

NO.1 Which default UID is defined during the installation of ITNM?

A. smadmin

B. itnmadmin

C. itmroot

D. itsmadmin

Answer: A

NO.2 Which statement is true regarding add scoping for Non-IP Layer 1 optical devices?

A. Scoping for non-IP Layer 1 optical devices should be configured in the FnderRetProcessing stitcher(CollectorFinder section).

B. Scoping for non-IP Layer 1 optical devices should be configured in the pre-discovery filter.

C. Discovery scoping is based on IP subnet zones. If the device has no IP address, scoping cannot be applied.

D. Scoping for non-IP Layer 1 optical devices should be configured in the Collector configuration.

Answer: D

NO.3 Assuming a good working ITNM Failover setup, which two statements are true for the backup domain when it is considered standby?

A. ncp_disco runs discoveries on the standby domain

B. ncp_poller engine runs with polls suspended

C. The Event Gateway enriches events on the ObjectServer

D. ncp_model updates NCIM upon successful discovery

E. ncp_virtualdomain communicates topology updates

Answer: B,C

NO.4 Which OMNIbus Probe acquires and processes the events that are generated by ITNM polls and processes and then forwards these events to the ObjectServer?

A. ncp_ncomonitor

B. nco_ncpmonitor

C. nco_p_ncpmonitor

D. nco_probe_ncpmonitor

Answer: C

NO.5 How can ITNM be configured to discover only a pre-defined set of network devices that are in a seed file?

A. Configure File Finder, for each Address in Scope list ensure that 'Add to Ping Seed List' option is unchecked, and ensure that Feedback control is enabled

B. Disable Ping Finder, uncheck File Finder Verification, configure File Finder, and disable Feedback Control

C. Enable Ping Finder but remove ping seeds, uncheck File Finder Verification, configure the File

Finder, and ensure that Feedback control is enabled

D. Configure File Finder, for each Address in Scope list ensure that 'Add to Ping Seed List' option is unchecked

Answer: B