H35-910 Dumps - HCS - Wireless Hardware Installation (Written)

Preparing for H35-910 HCS - Wireless Hardware Installation (Written) Exam? Passcert is a good website which provides you valid Huawei H35-910 Dumps to help you save time and energy to rapidly and efficiently master the Huawei certification H35-910 exam related knowledge. We guarantee your pass your H35-910 exam with high score in your first time.

Wireless hardware installation

EHS

Survey and design service process and key points of onsite survey

Introduction to survey tools and IT systems 

Logistic

If you want to successfully pass the Huawei H35-910 exam, the necessary part is to practice the H35-910 dumps. Because if you only study the H35-910 knowledge point, but you will not use it, then it will be very difficult to pass the H35-910 exam. The time we used to learn the H35-910 was very limited, and it was doomed that we could not have enough time to master all the H35-910 knowledge points. Therefore, we must grasp the key points. H35-910 exam focus can be determined through the H35-910 exam guide, and then focus on practicing H35-910 training material associated with the H35-910 exam.

Practicing the H35-910 dumps is also a learning process. By repeatedly practicing the H35-910 dumps, we will have a deeper understanding of many knowledge points and concepts. it is very helpful. For practicing the H35-910 dumps, we need to pay enough attention. Because the mastery of the H35-910 training material will directly affect the final H35-910 exam. Second, practicing the H35-910 dumps is not a very simple and easy process. We need to have enough patience and perseverance.

1. What is the name of cable connecting the RRU to the antenna?

A. Fiber

B. Network cable

C. 7/8 feeder

D. 1/2 jumper

Answer: D

2. Which of the following is the general cabinet power-on procedure?

A. Single board switch closed -> chassis module power switch closed -> cabinet input power distribution switch closed

B. Chassis module power switch closed -> cabinet input power distribution switch closed -> single board switch closed

C. Cabinet input power distribution switch closed -> Single board switch closed -> chassis module power switch closed

D. Cabinet input power distribution switch closed -> chassis module power switch closed -> Single board switch closed

Answer: D

3. Which of the following devices should the DBS3900 site include? (Multiple Choice)

A. BBU3900

B. RRU

C. ODF

D. Battery

Answer: AB

4. Which of the following modules cannot be installed in an APM 30H cabinet?

A. BBU3900

B. SPLU

C. RRU

D. EPU

Answer: C

5. Which of the following description is correct about the operation requirement?

A. Before entering the feed window, the power cord and fiber should be made to avoid the bay.

B. Before entering the room from the window, only the power cord is needed to avoid the bay.

C. All cables need to be used as a water-proof bay before entering the feeding window. The smaller the bending radius, the better.

D. Before entering the feed window, in addition to the fiber, the feeder and power line need to be used as a water bay.

Answer: A

6. What kind of grounding method is the grounding of the GPS arrester?

A. Working grounding

B. Protective grounding

C. Lightning protection grounding

Answer: C