3V0-41.19 VMware Advanced Design NSX-T Data Center 2.4 Exam is a hot VMware exam associated with the VCAP-NV Design 2020 Certification, Passcert new released VCAP-NV Design 2020 3V0-41.19 Dumps which enable you to grasp the knowledge of the certification exam within a short period of time. The accuracy rate of VCAP-NV Design 2020 3V0-41.19 Dumps provided by Passcert is very high and they can 100% guarantee you pass the VMware 3V0-41.19 exam successfully in your first time.

The Advanced Design NSX-T Data Center 2.4 exam (3V0-41.19) which leads to VMware Certified Advanced Professional – Network Virtualization 2020 certification is a 50-item exam, with a passing score of 300 using a scaled method. Candidates are given an appointment time of 105 minutes, which includes five-minute seating time and adequate time to complete the exam for non-native English speakers. Actual exam time is 100 minutes.

Advanced Design NSX-T Data Center 2.4 exam tests an individual’s ability to gather customer requirements, risks, constraints, and assumptions, and use that information to make design recommendations for NSX-T Data Center 2.4 solutions.

Section 1 – Architecture and Technologies

Section 2 – Products and Solutions

Section 3 – Planning and Designing

Section 4 – Installing, Configuring, and Setup

Section 5 – Performance-tuning, Optimization, and Upgrades

Section 6 – Troubleshooting and Repairing

Section 7 – Administrative and Operational Tasks

A. LAG Uplink Profile

B. Transport Node Profiles

C. LLDP Profile

D. Network I/O Control Profiles

A. Configure the Transport Node Uplink Profile to use a Load Balance Source teaming policy with two active uplinks.

B. Deploy an additional Edge Node to the Edge Node Cluster.

C. Replace the existing network switches and routers with newer higher-performance.

D. Replace the existing NICs with a model that supports GENEVE offload.

A. A transport node can attach single VLAN transport zones with single N-VDS.

B. An N-VDS with the same name can be attached to both Overlay and VLAN transport zones.

C. An N-VDS can attach to both an Overlay and a VLAN transport zone to a N-VDS having different name/s.

D. An N-VDS can only attach to a single Overlay transport zone.

E. An N-VDS can only attach to a single VLAN transport zone.

F. An N-VDS can only attach to a multiple VLAN transport nodes.

A. Deploy a Tler-1 gateway and connect It to an Active/Active Tier-0 gateway with ECMP configured.

B. Deploy an Active/Active Tier-0 gateway and configure ECMP.

C. Create two separate VLANs to connect the Tier-0 gateway upstream traffic and configure ECMP.

D. Deploy an Active/Passive Tier-0 gateway and configure ECMP.

A. Create and document the logical and virtual design.

B. Gather and document requirements, assumptions and constraints.

C. Build, deploy, implement and test the design.

D. Measure performance against customer's requirements.

A. Latency must be less than 150ms.

B. Bandwidth must be at least 10Gbps.

C. MTU is recommended to be 9000.

D. MTU must be at least 1700.

E. Latency RTT is acceptable.